Connecting the
AB EtherNet/IP in-
terface
Pin assignment
for RJ 45 Ether-
Net connection
Configuring the
The configuration of the Anybus-S EtherNet/IP bus module is carried out via an EtherNet-
TCP/IP
Gate:
-
-
-
70
(1)
(2)
Pin
Signal
1
TD+
2
TD-
1
8
3
RD+
4
-
5
-
6
RD-
7
-
8
-
Start / Programs / Fronius Product Group / Service Module
Select EtherNet-Gate (no: xxxxxxxx)
Click the Configuration button
Further information on the "special 2-step
mode for robot interface" can be found in
the power source operating instructions.
Connect LocalNet plug on the inter-
1
connecting hosepack to the LocalNet
connection (1)
Connect the Ethernet/IP data cable to
2
the Ethernet RJ 45 connection
(3)
Remark
-
-
-
Not normally in use; to ensure signal integrity, these pins
are connected to each other and terminate via a filter circuit
on the ground conductor (PE).
-
Not normally in use; to ensure signal integrity, these pins
are connected to each other and terminate via a filter circuit
on the ground conductor (PE).
NOTE! While the robot interface is
connected to the LocalNet, "2-step
mode" automatically remains se-
lected (display: 2-step mode).