Publicité
The transmitter should also feature a servo reverse facility.
We particularly recommend mx-12 to mc-24 computer systems. The model is
designed for standard-size servos.
We recommend the following receiver battery: GRAUPNER 4-2000 NIMH, Order No.
3415; the pack should be properly maintained before and after each flying session.
Please remember that the battery needs to be cycled (charged and discharged)
several times before it reaches full rated capacity.
For connecting the aileron servos to the receiver you will need two suppressor filters,
Order No. 1040, or one folding ferrite ring, Order No. 98516, together with two
extension leads, Order No. 3935.11.
The two aileron servo leads should be extended using extension leads, Order No.
3935.32.
Foam padding for the receiver and receiver battery are included in the kit.
The model is designed for standard-size servos.
Adhesives
Fast-setting epoxy resin, e.g. UHU plus schnellfest, Order No. 962
Slow-setting epoxy resin, e.g. UHU plus endfest, Order No. 950
White glue, e.g. UHU coll, Order No. 958.60
UHU hart cellulose cement, e.g. Order No. 534
Cyano-acrylate glue ("cyano"), e.g. Order No. 5821
Thread-lock fluid, e.g. Order No. 952
Accessories for flying the model (not included)
Synthetic oil based glow fuel, to suit motor
Fuel filter, e.g. Order No. 1650.1
Fuel tubing, e.g. Order No. 1643
Manual fuel pump, e.g. Order No. 1610 or 6870
Glowplug energiser battery and clip, e.g. Order No. 3248
Electric starter, e.g. Order No. 1628
Starter battery, e.g. Order No. 2592
Tools required (not included)
Various (cross-point) screwdrivers, pointed-nose pliers, flat-nose pliers, side-cutters,
balsa knife or razor blade, set of twist drills, universal glowplug spanner, pencil, felt-
tip pen, fine-tip soldering iron, Z-bend pliers, Order No. 5732.
Assembling the KWIK FLY MK 3
Do not start assembling the model until you have examined the kit components and
are familiar with all the stages of construction. If you are not satisfied with any part,
take it back to the model shop where you purchased the kit before you start work on
it.
Use your fingertips to locate the slots in the fuselage for the tailplane and fin, and
melt away the film over them using the tip of a hot soldering iron. Repeat the
procedure with the slots in the wing panels for the undercarriage units.
Slide the tailplane and fin into the slots in the fuselage, and position them accurately
(central and square).
GRAUPNER GmbH & Co. KG D-73230 KIRCHHEIM/TECK GERMANY
Änderungen vorbehalten! Keine Haftung für Druckfehler
02/2007
33
Publicité
