MINN KOTA ULTERRA Instructions D'installation page 9

8
m. Mount the motor to the boat using the provided
hardware. Place the installation hardware for the side
of the Motor where the Power Tilt is located first. This
is the opposite side of the Base Extrusion from where
the Extension Damper was removed. The base of the
Motor where the Power Tilt is located has Mounting
Slots and the side where the Extension Damper is
located has Mounting Holes.
9
ITEM(S) NEEDED
#6 x 3
NOTICE:
To prevent seizing of the stainless steel
hardware, do not use high speed installation tools.
Wetting the screws or applying an anti-seize may
help prevent seizing.
n. If installing with a Quick Release Bracket,
install the motor with the Hex Head Bolts (Item
#4) and Clipped Washers (Item #5). Orientate the
Clipped Washers so that the flat side of the washer
is towards the Base Extrusion. The Bolt should pass
through the Clipped Washer and into a Quick Release
Bracket. Leave at least 1/4" space between the Hex
Head Bolt and Clipped Washer in order to slide the
Base Extrusion under the Clipped Washer and into
place.
NOTICE:
The Long Bolts, Flat Washers and Nylock
Nut are not used when installing the Ulterra with a
Quick Release Bracket.
©2019 Johnson Outdoors Marine Electronics, Inc.
#3 x 3 #5 x 3
9n
INSTALLING THE ULTERRA
Power Tilt
#7 x 3
Hex Head
Bolt
Clipped
Washer
CAUTION
Use extra care to avoid pinching and damaging the sensor wires
that run along side of the Base Extrusion when installing and
tightening the motor mounting bolts.
Base Extrusion
Mounting Slots
#4 x 3
Quick Release Bracket
minnkotamotors.com | 9