MINN KOTA ULTERRA Instructions D'installation page 18

FEATURE OVERVIEW AND CONNECTING THE CABLES
The Built-in MEGA DI transducer will provide both MEGA Down Imaging and 2D CHIRP Digital Sonar to select Humminbird models. All
Built-In MEGA DI trolling motors, will come "Solix Ready" out of the box. An adapter cable accessory (MKR-MI-1 1852088 or MKR-
MDI-2 1852086) is available for purchase that will allow the connection of any compatible Humminbird Helix fish finder. The MKR-MI-1
is used on Helix 8, 9, 10 and 12 models. The MKR-MDI-2 is used for Humminbird Helix 7 models only. See the
Imaging Compatibility chart online.
NOTICE:
You can only view MEGA Down Imaging with a MEGA DI or MEGA SI HELIX G2N or G3N Series model and a required
adapter, or with any SOLIX Series model. The built-in transducer cannot supply MEGA Down Imaging to Humminbird models that
do not already have the capability. If you have a G2/G2N or a G3/G3N HELIX that is not a MEGA SI or MEGA DI model, you will still
get 2D CHIRP Digital Sonar from the transducer. SOLIX G1 and HELIX G2 and G2N units need to be running the latest software
update to view sonar from motors with Built-In MEGA Imaging. You can get the latest version of software for your fish finder online on
humminbird.com. Built-In MEGA DI is not supported by HELIX G1 models or other brands of fish finders.
1
a. Place the motor in the deployed position.
b. The Built-In MEGA Down Imaging connector from
the Control Head is a 14 pin connector. Built-In
MEGA Down Imaging may be installed on its own, or
in conjunction with an i-Pilot or i-Pilot Link system.
It will never be installed with Universal Sonar.
Locate and identify the correct connection for Built-in
MEGA Down Imaging cable(s), at the base of the
Control Head.
NOTICE:
Built-in MEGA Down Imaging is
always paired with either i-Pilot or i-Pilot Link on
Terrova, Ulterra and Ultrex motors.
Fourteen Pin
Connector
Built-in MEGA Down
Imaging cable from
Trolling Motor
18 | minnkotamotors.com
i-Pilot
Link
Routing
NOTICE:
Critical cable routing for 60" and 72" motors
with i-Pilot Link and Built-in MEGA Imaging. Accessory
Cables must exit the Coil Cord leaving three or more open
coils between where the cables exit and the motor base; as
assembled by the factory. Routing the cables in any other
manner will not allow the motor to stow properly.
Built-in MEGA Down Imaging
Built-In MEGA Down
Built-in MEGA
Control
Down Imaging
Head
Coil
Critical
Cord
Cable
Mount
©2019 Johnson Outdoors Marine Electronics, Inc.