MINN KOTA ULTERRA Instructions D'installation page 12

INSTALLING THE ULTERRA
13
v. At this point in the installation process the Motor
should be secured to the deck of the boat, and
the Motor can now be reassembled. The Extension
Damper can be slid back in place on the Damper
Pins. This should be done so the shaft on the
Damper is pointing inboard. Reinstall the two 5/16"
E-clips.
14
w. Replace the Right Sideplate.
x. Replace the Left Sideplate.
y. Replace the four sideplate Screws using a #2 or #3
Phillips Screw Driver.
14x
Left Sideplate
Screw
15
ITEM(S) NEEDED
#18 x 4
z. Take the Foot Pedal (Item #EE) and turn it over.
Put a Foot Pedal Pad (Item #18) in each of the pad
locations.
NOTICE:
The pads are recommended when using
the Foot Pedal on non-carpeted surfaces.
12 | minnkotamotors.com
Screw
#EE x 1
E-clips
14w
Screw
Foot Pedal
Bottom
Pad Placement
Damper Pins
Extension
Damper
Screw
Right Sideplate
Foot Pedal
©2019 Johnson Outdoors Marine Electronics, Inc.