MINN KOTA ULTERRA Instructions D'installation page 15

2
c. The cable(s) should be fed all the way through the Coil
Cord. It/they should exit the Coil Cord at the bottom of
the Coil Cord, where it connects to the Mount.
Two Connections
i-Pilot
Link
NOTICE:
Critical cable routing for 60" and 72" motors with
i-Pilot Link and Built-in MEGA Imaging. Accessory Cables
must exit the Coil Cord leaving three or more open coils
between where the cables exit and the motor base; as
assembled by the factory. Routing the cables in any other
manner will not allow the motor to stow properly.
FEATURE OVERVIEW AND CONNECTING THE CABLES
The cables from the Control Head, for each feature installed on the trolling motor, are separately connected to an output device. Once the
features that may be installed are identified, follow the instructions below to ensure the cables are connected correctly.
Built-In MEGA Side Imaging
MEGA Imaging technology took fish finding into the megahertz frequency for the very first time. Now built-In MEGA Side Imaging+
delivers up to 3X the output of standard Side Imaging
and expanding the side coverage areas, all while improving the crystal clear imagery. Built-In MEGA Side Imaging+ comes available in the
Minn Kota flagship families of trolling motors, including Ultrex and Ulterra, with 200 feet of coverage on either side of your boat. With
Humminbird MEGA imaging sonar built right into the trolling motor, you now have a crystal clear view of what's directly to the left and
right of your boat, without having to manage all of the cables that come with external transducers. The Built-In MEGA SI transducer is
only available on new models equipped from the factory and cannot be added to an existing trolling motor.
The Built-in MEGA SI transducer will provide MEGA Side Imaging to select Humminbird models. All Built-In MEGA SI trolling motors,
will come "Solix Ready" out of the box. An adapter cable accessory (MKR-MI-1 1852088) is available for purchase that will allow the
connection of any compatible Humminbird Helix fish finder. The MKR-MI-1 is used on Helix 8, 9, 10 and 12 models. See the
MEGA Side Imaging Compatibility
©2019 Johnson Outdoors Marine Electronics, Inc.
FEATURE OVERVIEW AND CONNECTING THE CABLES
Control Head
Built-in MEGA
Down or Side
Imaging or
Universal Sonar
Coil
Critical
Cord
Cable
Routing
Mount
. Humminbird improved this technology even further by extending the depth range
®
chart online.
One Connection
Built-in MEGA
Down Imaging or
Universal Sonar
NOTICE:
After the cable(s) exit(s) the Coil Cord, it/they
should be routed through an established routing system on
the boat, in an area with minimal interference. Power cables
or other elements that may produce interference for the sonar
signals. Inspect the selected route carefully to ensure that
there are no sharp edges, obstacles, or obstructions that may
damage the cables.
Coil Cord
Control
Head
Mount
Built-In
minnkotamotors.com | 15