MINN KOTA ULTERRA Instructions D'installation page 21

2
NOTICE:
The Universal Sonar Cable may not be
long enough to reach the fish finder. If the cable
length does not reach the desired fish finder
installation location, a 14.5' extension cable is
available to purchase. Minn Kota recommends
using the MKR-US2-11.
d. Take the Universal Sonar Extension Cable, if needed,
and attach it to the Universal Sonar Cable exiting
the Control Head. Firmly push the plug together and
twist the locking collar until it is snug.
e. Install the Universal Sonar Cable that exists the
Control Head or the Universal Sonar Extension
Cable (if used) to the appropriate Universal Sonar
Adapter Cable. Install the Adapter Cable to your fish
finder. Refer to your fish finder manual for complete
installation instructions.
NOTICE:
If any cables need to be routed, please
follow the guidelines in the Routing Connection
Cables section of these installation instructions.
i-Pilot Link
i-Pilot Link allows your Minn Kota trolling motor and Humminbird to
communicate with each other to change the way you fish. i-Pilot Link
delivers a large array of GPS capabilities including controlling speed,
steering, Spot-Lock, and the ability to record and retrace paths on the water, all at your fingertips. To learn more about the GPS
capabilities available with your i-Pilot Link navigation system, please refer to the Owner's Manual by visiting minnkotamotors.com.
The i-Pilot Link remote and controller make up the i-Pilot Link navigation system. The i-Pilot Link remote comes paired to the controller
from the factory. The i-Pilot Link controller contains a very sensitive compass and is where all GPS satellite and i-Pilot Link remote signals
are received. The i-Pilot Link controller is contained in the trolling motor Control Head and is connected to a fish finder from a connection
cable that exits the Control Head.
The Ethernet cable for the i-Pilot Link system has an 8 pin connector. The i-Pilot Link system can be connected directly to the
Humminbird or to the Humminbird Ethernet Switch (optional). If you purchase an Ethernet Switch, install it using the instructions
included in the Ethernet Installation Guide. A 30' Ethernet Extension Cable has been included with every motor equipped with i-Pilot Link.
It may or may not be needed for every installation. To purchase Ethernet switches, Ethernet cables, and extension cables, visit the web
site humminbird.com or call Humminbird Customer Service at 1-800-633-1468. Depending on the shape of the Ethernet port on your
Humminbird fish finder, an additional ethernet adapter cable
©2019 Johnson Outdoors Marine Electronics, Inc.
FEATURE OVERVIEW AND CONNECTING THE CABLES
2d
Four Pin Connector
Universal Sonar
Cable from
Trolling Motor
2e
Universal Sonar Cable from
Trolling Motor OR Universal
Sonar Extension Cable
NOTICE:
connection. The i-Pilot system does not need an external
wired connection.
(Ethernet Adaptor Cable AS EC QDE #720074-1 for Helix fish
Locking Collar
NOTICE:
The connectors are keyed to prevent reversed
installation.
Locking Collar
The i-Pilot Link system needs an external wired
Universal Sonar
Extension Cable
Universal Sonar
Adapter Cable to
fish finder
finders) may be
minnkotamotors.com | 21