MINN KOTA ULTERRA Instructions D'installation page 22

FEATURE OVERVIEW AND CONNECTING THE CABLES
required for the installation. Refer to your fish finder operations manual or see the
all compatible Humminbird Units and SD Cards.
1
a. Place the motor in the deployed position.
b. The i-Pilot Link connector from the Control Head is
an 8 pin connector. Locate and identify the correct
connection for i-Pilot Link, at the base of the
Control Head.
NOTICE:
i-Pilot Link will be paired with either
Built-in MEGA Down Imaging, Side Imaging or
Universal Sonar on Ultrex, Ulterra or Terrova.
NOTICE:
Paired with a Universal Sonar connector
for illustration purposes. A Built-in MEGA Down
Imaging connector may be present instead.
NOTICE:
Critical cable routing for 60" and 72" motors with i-Pilot Link and Built-in MEGA Imaging. Accessory Cables must
exit the Coil Cord leaving three or more open coils between where the cables exit and the motor base; as assembled by the
factory. Routing the cables in any other manner will not allow the motor to stow properly.
2
ITEM(S) NEEDED
c. If necessary, to reach the installed fish finder, take the
i-Pilot Link Ethernet Cable (Item #16) and attach it to
the i-Pilot Link cable exiting the Control Head.
NOTICE:
If any cables need to be routed, please
follow the guidelines in the Routing Connection
Cables section of these installation instructions.
d. Install the i-Pilot Link Ethernet Cable directly into
the Humminbird fish finder, or refer to your fish
finder installation manual for complete installation
instructions. If an Adapter Cable is needed (Ethernet
Adaptor Cable AS EC QDE for Helix fish finders),
install it on the end of the i-Pilot Link Ethernet Cable
and refer to your fish finder installation manual for
complete installation instructions.
22 | minnkotamotors.com
#16 x 1
i-Pilot Link Compatibility Chart
Control Head
i-Pilot
Link
Built-in MEGA
Down Imaging,
Side Imaging or
Universal Sonar
Critical
Routing
Eight Pin
Connector
Locking Collar
i-Pilot Link Ethernet
Cable from Trolling Motor
NOTICE:
The connectors are keyed to prevent reversed
installation.
on our web site with a list of
Coil
Cord
Cable
Mount
i-Pilot Link Ethernet
Extension Cable OR
Ethernet Extension Cable
©2019 Johnson Outdoors Marine Electronics, Inc.