MINN KOTA ULTERRA Instructions D'installation page 10

INSTALLING THE ULTERRA
10
o. If installing directly to the boat deck,
motor with the Long Bolts (Item #3), Clipped Washer
(Item #5), Flat Washer (Item #6) and Nylock Nut
(Item #7). Orientate the Clipped Washers so that the
flat side of the washer is towards the Base Extrusion.
The Bolt should pass through the Clipped Washer,
the Rubber Washer and then through the Boat Deck.
The Bolt should be secured by first adding the Flat
Washer (Item #6) to the Bolt and securing with a
Nylock Nut (Item #7). Leave at least 1/4" space
between the Hex Head Bolt and Clipped Washer and
the deck of the boat. This will leave enough space to
slide the Base Extrusion between the Clipped Washer
and Rubber Washer and into place.
NOTICE:
The Short Bolts are not used when
installing the Ulterra directly to the boat.
11
p. Slide the Base Extrusion into place under the Bolts
that were just installed.
q. If installing with a Quick Release Bracket,
the Base Extrusion should slide between the Quick
Release Bracket and the Clipped Washers. Hold the
Clipped Washers up on the Hex Head Bolt, so the
Clipped Washer will sit on top of the Base Extrusion.
r. If installing directly to the boat deck,
Extrusion should slide between the Clipped Washer
and the Rubber Washer. Hold the Clipped Washers
up on the Long Bolt, so the Clipped Washer will sit
on top of the Base Extrusion.
10 | minnkotamotors.com
install the
10o
Long
Bolts
Clipped
Washer
Rubber
Washer
Washer
Nylock
Nut
11q
the Base
Quick Release Bracket
11r
Boat Deck
Power
Tilt
Flat
Power Tilt
Clipped
Washer
Power Tilt
Clipped
Rubber
Washer
Washer
©2019 Johnson Outdoors Marine Electronics, Inc.
Boat Deck
Base
Extrusion
Base Extrusion