MINN KOTA ULTERRA Instructions D'installation page 16

FEATURE OVERVIEW AND CONNECTING THE CABLES
NOTICE:
You can only view MEGA Side Imaging with a MEGA DI or MEGA SI HELIX G2N or G3N Series model and a required
adapter, or with any SOLIX Series model. The built-in transducer cannot supply MEGA Down Imaging to Humminbird models that do
not already have the capability. If you have a G2/G2N or a G3/G3N HELIX that is not a MEGA SI or MEGA DI model, you will still get
2D Dual Spectrum CHIRP Sonar from the transducer. SOLIX G1 and HELIX G2 and G2N units need to be running the latest software
update to view sonar from motors with Built-In MEGA Imaging. You can get the latest version of software for your fish finder online on
humminbird.com. Built-In MEGA SI is not supported by HELIX G1 models or other brands of fish finders.
1
a. Place the motor in the deployed position.
b. The Built-In MEGA Side Imaging connector from the
Control Head is a 14 pin connector. Built-In MEGA
Side Imaging is only installed with motors installed
with the i-Pilot Link system. Locate and identify the
correct connection for Built-in MEGA Side Imaging
cable(s), at the base of the Control Head.
NOTICE:
Built-in MEGA Side Imaging is only
paired with i-Pilot Link on either an Ultrex or
Ulterra motor.
Built-in MEGA Side Imaging
16 | minnkotamotors.com
Built-in MEGA Side
Imaging cable from
Trolling Motor
Fourteen Pin
Connector
i-Pilot
Link
Built-in MEGA
Side Imaging
Critical
Cable
Routing
NOTICE:
Critical cable routing for 60" and 72" motors
with i-Pilot Link and Built-in MEGA Imaging. Accessory
Cables must exit the Coil Cord leaving three or more open
coils between where the cables exit and the motor base; as
assembled by the factory. Routing the cables in any other
manner will not allow the motor to stow properly.
©2019 Johnson Outdoors Marine Electronics, Inc.
Control
Head
Coil
Cord
Mount