MINN KOTA ULTERRA Instructions D'installation page 19

2
c. When installing with a Solix, the Built-In MEGA
Down Imaging cable can be plugged directly into
the Solix fish finder. Plug the Built-in MEGA Down
Imaging cable into the corresponding connection on
the Solix fish finder.
d. When installing with a Helix, first attach the Adapter
Cable and then plug the Adapter Cable into the
Helix fish finder. The Adapter Cable will only have
one connection that is keyed on the back of the
Helix fish finder. Plug the Adapter Cable into the
only matching keyed connection on the Helix
fish finder.
NOTICE:
Check for compatibility or any required
adapter cables online at minnkotamotors.com.
The cable from the trolling motor can be extended
with a 10' Extension Cable #720081-1
humminbird.com.
NOTICE:
If any cables need to be routed, please
follow the guidelines in the Routing Connection
Cables section of these installation instructions.
NOTICE:
The connectors are keyed to prevent
reversed installation.
Universal Sonar
Your trolling motor may be pre-installed with a Universal Sonar transducer system. Universal Sonar is a 2D sonar transducer with a
temperature sensor that is integrated into the lower unit of the trolling motor. It has an operating frequency of 83/200 kHz. Connecting
this transducer to a compatible fish finder gives you a 2D sonar view of what is happening directly below your trolling motor. The
integrated design protects the transducer from underwater hazards, and prevents tangles and damage to the transducer cables.
All Universal Sonar motors are equipped with an internal bonding wire, incorrect rigging will cause sonar interference and can damage
your trolling motor, electronics and other boat accessories. To minimize trolling motor interference, ensure that the fish finder and trolling
motor are powered by separate batteries. Please refer to the Battery & Wiring Installation and Motor Wiring Diagram sections of this
manual for correct rigging instructions.
©2019 Johnson Outdoors Marine Electronics, Inc.
FEATURE OVERVIEW AND CONNECTING THE CABLES
Humminbird Solix Fish Finder
Humminbird Helix Fish Finder
found at
Keyed Adapter Cable
for Helix Fish Finder
Fourteen Pin Connector
Locking Collar
Built-In MEGA Down Imaging
from Trolling Motor
Fourteen Pin Connector
Adapter Cable
Locking Collar (Helix ONLY)
Built-In MEGA
Down Imaging from
Trolling Motor
NOTICE:
The MKR-MI-1 is used on Helix 8, 9, 10 and
12 models. The MKR-MDI-2 is used for Humminbird
Helix 7 models only.
Solix Fish Finder
Connection
Plug directly into
Solix Fish Finder
Adapter
Cable Keyed
Connection
Plug into
Helix Fish
Finder
minnkotamotors.com | 19