MINN KOTA ULTERRA Instructions D'installation page 14

ROUTING CONNECTION CABLES
ROUTING CONNECTION CABLES
Please follow these instructions for routing any and all of the cables present for any of the pre-installed features that may come with your
trolling motor. This routing should be followed whether there are one or two connection cables present. If you are unsure of the cables
present, please review the "Identifying Trolling Motor Features By Their Associated Cables" section of these Installation Instructions.
1
a. Place the motor in the deployed position.
b. Locate the Built-in MEGA Down Imaging, Built-in
MEGA Side Imaging, i-Pilot Link and/or Universal
Sonar cable(s), at the base of the Control Head.
CAUTION
Not following the recommended wire routing for the Built-in
MEGA Down Imaging, Built-in MEGA Side Imaging, i-Pilot
Link and/or Universal Sonar cable(s), if equipped, may cause
damage to the product and void your product warranty. Route
cables away from pinch points or other areas that may cause
them to bend in sharp angles. Routing the cables in any way
other than directed may cause damage to the cables by being
pinched or severed.
NOTICE:
Universal Sonar connector shown for
illustration purposes.
14 | minnkotamotors.com
One Connection Built-in MEGA Down
Imaging or Universal
Two Connections
i-Pilot
Link
Built-in MEGA
Down or Side
Imaging or
Universal Sonar
Control Head
Sonar
Coil Cord
Control Head
Coil Cord
©2019 Johnson Outdoors Marine Electronics, Inc.