MINN KOTA ULTERRA Instructions D'installation page 6

INSTALLING THE ULTERRA
MOUNTING CONSIDERATIONS
It is recommended that the motor be mounted as close to the keel or centerline of the
boat as possible. Make sure the area under the mounting location is clear to drill holes
and install nuts and washers. Make sure the motor rest is positioned far enough beyond
the edge of the boat. The motor must not encounter any obstructions as it is lowered into
the water or raised into the boat when stowed and deployed. Consider a quick release or
adapter bracket with the installation of your motor. To view a list of accessories, please
visit minnkotamotors.com.
TOOLS AND RESOURCES REQUIRED
• #2 Phillips Screwdriver
• #3 Phillips Screwdriver
INSTALLATION
INSTALLING THE ULTERRA
1
a. Place the Motor on an elevated, level surface such
as a workbench or the tailgate of a pickup. The
motor, as removed from the box, should be in the
stowed position.
b. Remove the four sideplate screws using a #3 or #2
Phillips screwdriver. Two of these screws will be
located on each side of the Motor Mount
Deployed
2
c. Remove the Right Sideplate to access the
Mounting Slots.
d. Remove the Left Sideplate to access the Mounting
Holes.
6 | minnkotamotors.com
• Drill
• 9/32" Drill Bit
.
Stowed
• A person to help with
installation
1b
Right
Sideplate
Screw
Screw
NOTICE:
This motor weighs approximately 70 lbs.
We recommend having a second person help with
the installation.
2c
Right
Sideplate
View accessories
available for your
trolling motor at
minnkotamotors.com.
1b
Screw
Screw
Left
Sideplate
2d
Left Sideplate
©2019 Johnson Outdoors Marine Electronics, Inc.