MINN KOTA ULTERRA Instructions D'installation page 7

3
e. Under the Left Sideplate, the Extension Damper
obstructs access to the left front Mounting Hole.
f. Using a small Screw Driver, remove the two
5/16" E-clips holding the Extension Damper in
place. Once the E-clips are removed, slide the
Extension Damper off the Damper Pins to expose
the left rear Mounting Hole. Set the two E-clips and
Extension Damper in a safe place so they are not
misplaced before they are reassembled later in the
installation.
WARNING
Do not deploy the motor until it is fully mounted to the boat.
Illustrations are for reference only. Deploying your motor
before it is mounted to the boat may cause injury.
4
g. Make sure the Power Cables from the battery
are disconnected, or that the breaker, if equipped, is
"off".
WARNING
Make sure the motor is mounted on a level surface and is not
connected to a power source.
5
h. Place the motor on the bow of the boat. Place the
motor as close to the centerline or keel of the boat
as possible. The motor can be installed on either the
Port or Starboard side of the boat based on personal
preference. Reviewing the mounting considerations
at the beginning of the installation section.
NOTICE:
The Emergency Strap (Item #9) is used for
Manually Stowing the Ulterra. The Emergency Strap is
not secured during installation. Store it on your boat
in the event that you would need to manually stow
the motor. To learn how, please refer to the "Manually
Stowing the Ulterra" section of the Owner's Manual.
©2019 Johnson Outdoors Marine Electronics, Inc.
INSTALLING THE ULTERRA
3e
E-clip
Extension
Damper
3f
E-clips
Power Cables
Mount
Keel
Mounting Hole
E-clip
Extension
Damper Pins
Damper
Deck of Boat
minnkotamotors.com | 7