MINN KOTA ULTERRA Instructions D'installation page 11

12
ITEM(S) NEEDED
#6 x 3
NOTICE:
To prevent seizing of the stainless steel
hardware, do not use high speed installation tools.
Wetting the screws or applying an anti-seize may
help prevent seizing.
s. Place the hardware on the Damper side of the
mount into the Mounting Holes to secure the Base
Extrusion.
If installing with a Quick Release Bracket,
t.
install the motor with the Hex Head Bolts (Item
#4) and Clipped Washers (Item #5). Orientate the
Clipped Washers so that the flat side of the washer
is towards the Base Extrusion. The Bolt should pass
through the Clipped Washer, Base Extrusion and
into a Quick Release Bracket.
NOTICE:
The Long Bolts, Flat Washers and Nylock
Nut are not used when installing the Ulterra with a
Quick Release Bracket.
If installing directly to the boat deck,
u.
install the motor with the Long Bolts (Item #3),
Clipped Washer (Item #5), Flat Washer (Item #6)
and Nylock Nut (Item #7). Orientate the Clipped
Washers so that the flat side of the washer is
towards the Base Extrusion. The Bolt should pass
through the Clipped Washer, the Base Extrusion, the
Rubber Washer and then through the Boat Deck.
The Bolt should be secured by first adding the Flat
Washer (Item #6) and then securing with a Nylock
Nut (Item #7).
NOTICE:
The Short Bolts are not used when
installing the Ulterra directly to the boat.
©2019 Johnson Outdoors Marine Electronics, Inc.
#3 x 3
#5 x 3
INSTALLING THE ULTERRA
#7 x 3
CAUTION
Use extra care to avoid pinching and damaging the sensor wires
that run along side of the Base Extrusion when installing and
tightening the motor mounting bolts.
12s
Mounting Holes
12t
Hex Head Bolt
Clipped
Washer
Mounting
Holes
Quick Release Bracket
12u
Long
Bolts
Clipped
Washer
Rubber
Washer
Flat
Washer
Nylock
Nut
Mounting Holes
#4 x 3
Boat Deck
minnkotamotors.com | 11