Locating And Storing The Lower Connectors; Connecting The Lower Connectors - Britax Chaperone Guide D'utilisation

8 Vehicle Compatibility
Only use the LCS on this infant carrier in a seating position designated
by the vehicle owner's manual. Refer to your vehicle owner's manual
or contact the vehicle manufacturer for the maximum weight rating for
their LUAS anchors.
This infant carrier was designed to be used with LUAS anchors in
vehicle designated seating positions. The standard vehicle seat spacing
between LUAS anchors is 27.9 cm (11 in). This infant carrier can be
used in a seating position with up to 50.8 cm (20 in.) of space between
the LUAS anchors if the vehicle manufacturer allows.
Check your vehicle
owner's manual for
information on using
child restraints in center
Up to 50.8 cm
seating positions without
designated LUAS anchors.
A

Locating and Storing the Lower Connectors

The lower connectors are located on the sides of the base inside the lower
connector storage slots. Store the lower connectors when not in use.
To remove the lower connectors from the storage slots:
1 Press and hold the red
release button.
(20 in.)
2 Pull the lower connector from
the storage slot.
To store the lower connectors:
Push the lower connector into the
storage slot until a click is heard to
store the lower connectors.
NOTE : The lower connectors are
stored with the "top" facing down
as shown.

Connecting the Lower Connectors

The lower connectors must be properly aligned with the vehicle LUAS
anchors to ensure a proper and secure connection.
Always check that the lower connector strap is not twisted and that the
lower connector is correctly aligned before connecting to the vehicle
LUAS anchor.
Top
NOTE : Ensure that the "top" of the lower connector is facing up when
securing the base in your vehicle.
Vehicle Compatibility 9
Top
Top