Securing Your Child; Replacing The Buckle; Low Birth Weight Infant Foam - Britax Chaperone Guide D'utilisation

52

Securing Your Child

Replacing the Buckle

1 Turn the buckle strap retainer
so that the short side will go
through the slot in the, foam
cover and infant carrier shell.
3 Pull the buckle away from the
infant carrier to ensure the
buckle strap retainer lies flat
against the infant carrier shell.
2 Thread the buckle strap
retainer through the desired
slot in the infant carrier shell
and cover to the bottom of the
infant carrier shell.
4 Check that the buckle strap
is not twisted and that the red
release button faces out.

Low Birth Weight Infant Foam

Low birth weight foam has been included with this infant carrier for infants
weighing 1.81 – 5 kg (4 to 11 lbs). This foam may be necessary for low birth
weight infants to achieve a snug fit of the harness around your child. Also
see page 6.
IMPORTANT: Do not use low birth weight foam for infants weighing more
than 5 kg (11 lbs). Always use inner buckle strap slot when using low birth
weight infant foam see pages 49 – 50.
To use the Low Birth Weight Infant Foam:
1
Pull the plastic flaps on the cover
from the infant carrier shell.
3
Slide the foam into place around
the buckle slots.
* The buckle can be removed as
described on pages 50 – 51 for
easier placement of the foam.
Securing Your Child 53
2
Pull the infant carrier cover and foam
back to access the buckle slots.
4
If the buckle was removed, thread
the buckle retainer through the
slot in the foam insert, foam pad,
and infant carrier shell.
* Ensure the buckle retainer lies
flat against the infant carrier shell.
5
Replace the cover.