Non-Locking Lap-Shoulder Belt Installation Using A Locking Clip - Britax Chaperone Guide D'utilisation

40 Installing Your Infant Carrier without Base
Non-Locking Lap-Shoulder Belt Installation Using a
Locking Clip
IMPORTANT: When installing this restraint using a non-locking vehicle
belt, a locking clip must be used. Refer to your vehicle owner's manual
for instructions on correct use of vehicle belts with child seats.
Before You Begin:
Ensure you have a locking clip.
9
Locking clips are available
for purchase by contacting
Britax Consumer Services at
1.888.427.4829.
Secure child in carrier before
9
installing carrier in vehicle
1
Place the infant carrier rear-facing
on the vehicle seat.
Carrier Installation with a Non-
Locking Lap-Shoulder Belt
2
Pull the vehicle belt out and route
the lap portion of the vehicle belt
through the first belt guide.
* Do not route the shoulder
portion of the vehicle belt
through the belt guides.
Installing Your Infant Carrier without Base
3
Route the lap part of the vehicle
belt through the second belt guide.
* Do not route the shoulder
portion of the vehicle belt
through the belt guides.
5
Push the infant carrier firmly into
the vehicle seat while removing
all slack from the lap portion, and
then the shoulder portion of the
vehicle belt.
7
Thread the locking clip onto both
belts, placing it within 2.5 cm (1 in.)
of the latch plate.
41
4
Verify that the vehicle belt is not
twisted and then buckle.
6
Hold the lap and shoulder belts
together behind the latch plate
and unbuckle.