Britax Chaperone Guide D'utilisation page 13

22 Installing the Base
Follow the steps below if adjustment of the recline angle is
necessary:
a
Press the LCS adjuster release
button to release tension in the
LCS strap.
c
Turn the recline adjustment knob
to adjust the recline angle.
e
Place the infant carrier in the base and check the recline angle.
Repeat the previous steps until a secure fit with proper recline angle
is achieved. Continue with installation instructions from step 7 on
page 20.
b
Press the lower connector
release button and detach the
lower connectors from the LUAS
anchors.
d
Connect and tighten the LCS
strap.
If there is a problem achieving the proper recline angle after following
the previous steps:
f
Uninstall the base and rotate the recline adjuster on the base to the
lowest position.
g
Remove the base from the vehicle seat.
h
Place a rolled towel or pool
noodle in the vehicle seat bight.
Installing the Base 23
i
Place the base on the towel or
pool noodle to help level the base
and continue installation from
step 7 on page 20.