Removing The Infant Carrier; Securing Your Child; Adjusting The Harness - Britax Chaperone Guide D'utilisation

46 Installing Your Infant Carrier without Base
Follow the steps below if adjustment of the recline angle is
necessary:
a
Unbuckle the seat belt.
b
Place a rolled towel or pool
noodle in the vehicle seat bight.
* See note below.
Repeat the previous steps until a secure installation with proper
recline angle is achieved. Continue with installation instructions from
step 2 on page 44.
NOTE : Configure pool noodle(s) to accommodate variations in
vehicle seat contour as necessary.

Removing the Infant Carrier

1 Unbuckle the vehicle belt.
Pull the vehicle belt from the infant carrier belt guides.
2
IMPORTANT: If you have installed the infant carrier using a locking clip,
ensure that the locking clip is removed before the vehicle belt is used
by a passenger not riding in a child restraint.
c
Place the infant carrier on the
towel or pool noodle to help level
the base.
Securing Your Child in the Infant Carrier
WARNING!
• Adjust harness to fit clothes the child is wearing. Remove bulky
coats and/or jackets before putting child in infant carrier.
• Adjust the belts provided with this child seat so they fit snugly
around your child. A snug strap should not allow any slack. It
lies in a relatively straight line without sagging. It does not press
on the child's flesh or push the child's body into an unnatural
position.
• Verify that the infant carrier is secure and that the harness is
properly adjusted around the child EACH time the infant carrier
is used. Failure to properly adjust the harness could result in
death or serious injury.

Adjusting the Harness

The harness should be properly adjusted to fit your child prior to
installing the infant carrier in your vehicle. Follow the steps below to
prepare the infant carrier harness for use with your child.
1 Unbuckle the harness by
pressing the red release
button and pulling the buckle
tongues from the buckle.

Securing Your Child

47
Press Press
Pull
2 Release the chest clip, by
pressing the release button
and pulling apart the two
halves.