SICK IN3000 Direct Mode D'emploi page 73

Operating instructions
IN3000 Direct
WARNING
8014173/YIJ3/2016-04-18
Subject to change without notice
Electrical installation
Prevent the occurrence of a potential difference
between the load and the protective device!
If you connect loads to the OUT1/OUT2 outputs,
then you must connect the 0 V connections for
these loads and the related protective device
separately, one after the other, to the same 0 V
terminal strip. Only then is it ensured that in the
case of a fault, it is not possible for a potential
difference to occur between the 0 V connections for
the loads and the related protective device.
© SICK AG • Industrial Safety Systems • Germany • All rights reserved
Chapter 5
73