Driving The Vehicle - Reely Dart 2.0 Notice D'emploi

Proceed as follows:
- Place the vehicle on an appropriate surface before connecting the drive batteries, so that the wheels
can turn freely.
- Switch off the speed controller.
- Insert the batteries in the transmitter and switch on the transmitter if this has not been done yet. Check
its function (e.g. operation display of the transmitter).
- Put the transmitter trimming for driving into the centre position.
- Connect a fully charged drive battery to the speed controller in the correct polarity (either one 6-cell
NiMH drive battery or a 2-cell LiPo drive battery).
- Now switch on the speed controller. Wait for a few seconds until the speed controller has completed
its self-test.
- If you have connected a LiPo drive battery, check that the undervoltage recognition is switched on
(see chapter 10. b). If this is not the case, switch it on before driving the vehicle. At operation of the
vehicle with an NiMH drive battery, the undervoltage recognition should be switched off to better use
the capacity of the rechargeable battery.
- Check that the vehicle reacts to remote control commands as expected (steering and drive) before
taking it from the support and placing it on the ground with its wheels.
d) Driving the Vehicle
• Improper operation can cause serious damage to people and property! Only drive with the model directly
in view. This is why you shouldn't drive at night.
• Only drive when your ability to react is unimpaired. Tiredness or the influence of alcohol or medication
can cause incorrect responses, just as with real vehicles.
• Please note that this model car must not be driven on public roads, places or streets. Also do not operate
it on private grounds without the owner's permission.
• Don't drive towards animals or people!
• Avoid driving at very low outdoor temperatures. Plastic parts lose elasticity, which may lead to damage
even in a light accident.
• Do not drive in thunderstorms; don't drive under high-voltage power lines or in the proximity of radio
masts.
• Don't drive in the rain, through wet grass, water, mud or snow. The model is not waterproof or watertight.
Moisture not only causes corrosion but also damages the electronics. In a lithium technology
rechargeable battery (e.g. LiPo rechargeable batteries), entering moisture may set the battery on fire or
even cause an explosion!
• As long as the vehicle is in operation you must always leave the transmitter switched on.
• When parking the vehicle, always switch off the vehicle's speed controller first and disconnect the drive
battery from the speed controller completely then.
Now you may turn off the transmitter.
38