Reely Dart 2.0 Notice D'emploi page 51

Setting Rear Axle Camber:
For setting the camber, twist the screw (A) of the upper
transverse link as for the front axle.
A suitable open-faced spanner can be used for turning
(not enclosed).
Because this screw has a left and right hand thread at
either end, the transverse link does not need to be dis-
mantled for the camber to be adjusted.
Note:
Change the settings only gradually and then check the changed running conduct to see if it corresponds to
your expectations. Write down the changes made so that you can easily reverse them again.
Twist the screws of the two transverse links at the front axle and the rear axle evenly at all times, since
different settings at the left/right wheel will cause unforeseeable driving behaviour.
51