Operating Limits; List Of Cables - Nice AVIO600 Instructions Et Avertissements Pour L'installation Et L'utilisation

3.1.1 – Operating Limits
Chapter 6 "Technical Characteristics" provides the fundamental data
needed to determine whether all the AVIO600 and AVIO1000 compo-
nents are suitable for the intended application. In general AVIO600 and
AVIO1000 are suitable for the automation of sectional and overhead
Model Maximum force
AVIO600
600N
AVIO1000 1000N
3.1.2 – List of cables
The cables required for the installation of AVIO may vary depending on the type and quantity of devices to be installed; figure 12 shows the cables
needed for a typical installation; no cable is supplied with AVIO.
12
F
E
C
B
A
D
Table 8: List of cables
Connection
[A] OPEN input
[B] STOP input
[C] SbS input
[D] I
BUS nput/output
[E] FLASH light output
[F] Radio aerial
Note 1 – For the BUS, STOP and SbS cables, there are no special contraindications to the use of a single cable that groups together multiple
connections; for example, a single 4x0,5mm
WARNING! – the cables used must be suitable for the type of installation; for example, an H03VV-F type cable is recommended for
indoor applications.
6 – English
doors for residential applications having the values shown in the table 7.
The shape of the door and the climatic conditions (e.g. presence of strong
wind) may reduce this maximum limit. In this case it is necessary to mea-
sure the torque needed to move the door under the worst conditions, and
to compare it to the data provided in the technical characteristics chart.
TABLE 7
SECTIONAL door
Height Width
2,4m 4,4m
3,4m 5,2m
Cable type
2 x 0,5 mm cable
2
2 x 0,5 mm cable
2
2 x 0,5 mm cable
2
2 x 0,75 mm cable
2
2 x 0,5 mm cable
2
RG58 type shielded cable
2 cable.
OVERHEAD door
non-protruding (with GA2)
Height Width
2,2m 4,2m
3,2m 5m
D
Maximum length allowed
20 m (note 1)
20 m (note 1)
20 m (note 1)
20 m
20 m
20 m (less than 5m recommended)
OVERHEAD door
protruding (with GA2)
or with springs (without GA2)
Height
2,8m
3,5m