Preliminary Checks - Nice AVIO600 Instructions Et Avertissements Pour L'installation Et L'utilisation

2.3.4 – FL200 flashing light with incorporated aerial (optional)
The flashing light is controlled by the control unit and signals danger when
the door is moving. Inside the flashing light there is also the aerial for the
radio receiver.
List of small parts for FL200
4,2X32 self-tapping screw
s 6 c nylon screw anchor
6
––– STEP 3 –––
The installation must be carried out by qualified and skilled
personnel in compliance with the directions provided in chapter
1 "WARNINGS".
3.1 – PRELIMINARY CHECKS
AVIO600 and AVIO1000 must not be used to power a door that
is not efficient and safe and cannot solve defects resulting from
incorrect installation or poor maintenance of the door itself.
WARNING: incorrect installation could cause serious damage.
Before proceeding with the installation you must:
• Make sure that the door movement does not hinder roads or
public footpaths.
• After the motor has been installed, remove unnecessary cables
or chains and turn off any unneeded equipment.
• Make sure that the weight and dimensions of the door fall within
the specified operating limits (Chapter 3.1.1). If they do not, AVIO
cannot be used.
4 – English
TABLE 6
Q.ty
Pcs 4
Pcs 4
INSTALLATION
2.3.5 – ECCO5... radio transmitter
The radio transmitter is used for the remote control of the door opening
and closing manoeuvres. It features 5 buttons that can all be used for the
5 types of command to a single automation unit, or to control up to 5 dif-
ferent automation units.
The transmission of the command is confirmed by the LED [A]; an eyelet
[B] allows them to be hung on a keyring.
7
T1
T3
• Make sure that the structure of the door is suitable for automa-
tion and in compliance with regulations in force.
• Make sure that there are no points of greater friction in the open-
ing or closing stroke of the door.
• Make sure that the mechanical structure of the door is sturdy
enough and that there is no risk of it derailing out of the guides.
• Make sure that the door is well balanced: it must not move by
itself when it is placed in any position.
• Make sure that the installation area is compatible with the size of
the gearmotor and that it is safe and easy to release.
• Make sure that the mounting positions of the various devices
are protected from impacts and that the mounting surfaces are
sufficiently sturdy.
• Make sure that the mounting surfaces of the photocells are flat
and that they enable the proper alignment between TX and RX.
• Pay attention in particular to the methods for securing the head
of the guide and the brackets to the ceiling. The head of the guide
will have to bear all the strain of opening and closing the door; the
ceiling-mounted brackets will have to bear all the weight of AVIO.
[A] Led
T5
T2
T4
[B]