Locking And Unlocking The Keypad; Before The Installation - Burkert 0911 Instructions De Service

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

CHANGING THE DEFAULT PARAMETERS
NOTE
All the parameter values can only be seen by repeatedly
pressing the SET1 buttons.

LOCKING AND UNLOCKING THE KEYPAD

2.3

Before the installation

PREDEFINE THE SENSOR TYPE
Enter a desired value with SET +
Then confirm with the SET button.
Enter a desired parameter with
Hold down the buttons
seconds. The POF message appears on the
display . The keyboard is locked. The POF
message also appears if you hold down a button for
longer than 3 s.
The keyboard will be unlocked if you hold down
the buttons
and
display for a few seconds.
The configurable input type is noted on the controller
label. Please enter this input type if it does not
corresponds to the connected sensor type.
Hold down the SET +
Select the parameter Pbc (sensor type) and then
confirm with the SET button to see the current
default.
Type TU (temperature controller):
J = Thermoelement J; Pt = Pt100;
C = Thermoelement K; Ptc = PTC;
S = Thermoelement S; ntc = NTC
Type AU
(control devices with voltage/current input):
cur = 4...20 mA; 0-1 = 0...1 V; 10 = 0...10 V
Confirm the default with the SET button.
Briefly switch off the power to the device.
or
.
or
.
and
for at least 3
for 3 s. POn appears in the
buttons for 3 seconds.
0911 - 7

Publicité

Table des Matières
loading

Table des Matières