Burkert 0911 Instructions De Service page 8

CHANGING SET-VALUE 1 / SET-VALUE 2
ENTER PROGRAMMING LEVEL
USER LEVEL PR1
SERVICE LEVEL PR2 (PASSWORD 321)
ADDING/REMOVING PARAMETERS IN THE USER LEVEL PR1
6 - 0911
Hold down the SET button for 2 seconds.
Change the set-value within 10 s with the
buttons.
You can save the new set-value by briefly pressing
the SET button or by waiting 10 seconds.
Hold down the SET1 +
seconds.
Select with Pr2 and then confirm with the SET1
button.
Enter the password 321 and then confirm with the
SET1 button.
Enter the „3" and then 1x SET1 button
Enter the „2", and then 1x the SET1 button
Enter the „2", and then 1x the SET1 button
You are now in the Parameter List.
Hold down the SET1 +
seconds. PR1 contains all the parameters that can
be accessed by the user. The device shows the first
parameter that is available in the user level.
See: Accessing the programming level .
Accessing the programming level
The status can be changed with the SET1 +
buttons.
If a parameter is not visible in the PR1 level, this will
be indicated by an LED point.
or
button for at least 3
button for at least 3