Burkert 0911 Instructions De Service page 14

Digital inputs
Temperature increase/
HES
Reduction
Function of the digital
i1F
Input
i1P Polarity of the digital
input
did Alarm delay time
of the digital input
(0...120 min)
Miscellaneous
Adr Serial address RS485
(1...247)
OnF Set device to STAND-BY
Ptb Number of the parameter-
table
rEL Version
Pr2 Display of the parameters
in Level Pr2
NOTE
12 - 0911
You can access hidden parameters by holding down the
keys SET + for 3 sec in the programming level HY. The
message Pr2 appears.
Set-value is increased/lowered by HES
during an energy-saving phase
Activation via digital input
(i1F = Es).
EAL = external alarm; OFF = unused;
bAL = serious external alarm;
Es = Energy saving mode Start/Stop;
onF = switch the device ON/OFF
externally;
C-H = reverse the control effect
CL: active with closed contact
OP: active with opened contact
For i1F = EAL or i1F = bAL.
The corresponding alarm then takes
place display or message.
Address for XJ500 recording
system. Identifies the device if it
is linked into a ModBUS-compatible
system.
no = not possible via keyboard
yes = STAND-BY can be activated by
holding down the SET button for
at least 4 sec. If you want to change the
set-value, hold down the SET button for
approx. 2 sec.
only read-out value
only read-out value
display only