Locking And Unlocking The Keypad; Before The Installation - Burkert 0911 Instructions De Service

CHANGING THE DEFAULT PARAMETERS
NOTE

LOCKING AND UNLOCKING THE KEYPAD

2.3

Before the installation

PREDEFINE THE SENSOR TYPE
Enter a desired value with SET +
Then confirm with the SET button.
Enter a desired parameter with
All parameter values can be seen by repeatedly pressing the
SET buttons.
Hold down the buttons
seconds. The message POF appears on the
display. The keyboard is locked. You can only
view the set-value and the minimum and maximum
temperature. The POF message also appears if
you hold down a button for longer than 3 s.
The keyboard will be unlocked if you hold
down the buttons
in the display for a few seconds.
The configurable input type is noted on the controller
label. Enter this input type if it corresponds to the
connected sensor type.
Hold down the SET +
seconds.
Select the parameter Pbc (sensor type) and then
confirm with the SET button to see the current
default.
Type TU (temperature controller):
J = Thermoelement J; Pt = Pt100;
K = Thermoelement K; Ptc = PTC;
S = Thermoelement S; ntc = NTC
Type AU
(control devices with current/voltage input):
cur = 4...20 mA; 0-1 = 0...1 V; 10 = 0...10 V
Confirm the default with the SET button.
Briefly switch off the power to the device.
or .
or .
and for at least 3
and for 3 s. POn appears
button for at least 3
0911 - 7