Troubleshooting; Technical Data - Cleanmaxx PC-P006EA Mode D'emploi

7. Put on the exhaust air compartment covers (4). When you do this, make sure that the
locking lugs sit in the recesses which are provided for them.
8. Twist the exhaust air compartment covers (4) in the opposite direction again to secure
them in place. They must engage audibly.

Troubleshooting

If the device does not work properly, fi rst check whether you are able to rectify the prob-
lem yourself.
Do not attempt to repair a defective electrical device yourself!
Problem
The device
generates no
suction.
The performance is
weak.
Dust escapes from
the device during
cleaning.
During vacuum
cleaning, an
unpleasant smell is
detected.

Technical Data

Model number:
Article number:
Voltage supply:
Power:
Protection class:
23
Possible cause / solution / tips
• Is the mains plug inserted in the socket correctly? Correct the
fi t of the mains plug.
• Is the plug socket defective? Try another plug socket.
• Check the fuse of the mains connection.
• Are the fi lters clogged? Clean all fi lters.
• Is the dust container (8) too full? Empty the dust container (8).
• Are the fi lters heavily clogged? Clean all fi lters.
• Is the nozzle, the extension tube (6) or the suction hose (5)
clogged? Switch off the device, pull the mains plug out of the
plug socket and remove the cause of the blockage (also see
the "Assembly" chapter).
• Is the dust container (8) not closed correctly and / or not
(correctly) inserted into the device? Correct the fi t of the dust
container (8).
• Is the device being used for the fi rst time? A smell often
develops when new devices are fi rst used. The smell should
disappear once the device has been used several times.
PC-P006EA
01593
220 – 240 V ~ 50 Hz
600 W
II
Customer Service / Importer:
DS Produkte GmbH
Am Heisterbusch 1
19258 Gallin
Germany
Tel.: +49 38851 314650
(Calls to German landlines are
subject to charges. The cost varies
depending on the service provider.)
EN