Cleanmaxx PC-P006EA Mode D'emploi page 20

EN
Inserting / Removing the Extension Tube
Attaching / Removing the Floor Nozzle
• Attaching: Plug the fl oor nozzle into the suction opening (7) on the main device (3),
onto the free end of the extension tube (6) or the suction hose (5). Twist the nozzle
back and forth slightly as you do this.
• Removing: Simply pull off the fl oor nozzle.
Attaching / Removing the Turbo Nozzle
Note: The turbo nozzle cannot be used with the suction hose (5).
• Attaching: Plug the turbo nozzle either directly into the suction opening (7) on the
main device (3) or onto the free end of the extension tube (6). When you do this,
make sure that the release lever is heard to engage.
• Removing: Press the release lever and pull out the turbo nozzle.
Attaching / Removing the Crevice / Brush Nozzle
• Attaching: Plug the nozzle adapter into the suction opening (7) on the main de-
vice (3), onto the free end of the extension tube (6) or the suction hose (5). Then plug
the nozzle you want on as far as it will go. Twist the nozzle back and forth slightly as
you do this.
• Removing: Simply pull off the nozzle used and the nozzle adapter.
Inserting / Removing the Dust Container
20
• Inserting: Plug the connection tube (6) into the suction
opening (7) on the device. When you do this, make sure
that the release lever is heard to engage.
• Removing: Press the release lever and pull out the exten-
sion tube (6).
• Removing: Press the release button of the dust contain-
er (8) and remove it from the main device (3).
Caution: The dust container (8) is open at the top. You
should therefore always hold the device with the suction
opening pointing downwards when the dust container (8)
is removed!
• Inserting: First place the top, open part of the dust contain-
er (8) onto the device. Then press the dust container (8)
down until it is heard to lock in place.