Burkert 0911 Instructions De Service page 8

ENTER PROGRAMMING LEVEL
USER LEVEL PR1
SERVICE LEVEL PR2 (PASSWORD 321)
ADDING/REMOVING PARAMETERS IN THE USER LEVEL „PR1"
CHANGING THE DEFAULT PARAMETERS
6 - 0911
Hold the SET + buttons down for at least 3
seconds
Select with Pr2 and then confirm with the SET
button.
Enter the password 321 and then confirm with the
SET button.
Enter the „3" and then 1x SET button
Enter the „2", and then 1x the SET button
Enter the „1", and then 1x the SET button
You are now in the Parameter List.
Press down the SET +
PR1 contains all the parameters accessible to the
user. The device shows the first parameter that is
available in the user level.
See: Accessing the programming level.
Accessing the programming level
The status can be changed with the SET +
buttons.
If a parameter is not visible in the PR1 level, this will
be indicated by an LED point.
Enter a desired value with SET +
Then confirm with the SET button.
Enter a desired parameter with
buttons for 3 seconds.
or .
or .