Hot-Key Function - Burkert 0911 Instructions De Service

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

5

HOT-KEY function

DOWNLOAD (HOT-KEY
Writing the stored parameter set from the HOT-KEY into the control device:
Switch off the electrical power to the controller, or set it to STAND-BY.
Insert the HOT-KEY up to the stop in the marked position on the controller.
Re-activate the controller.
The default parameters in the HOT-KEY will be automatically written into the
controller. During this time, the message DoL blinks in the display. The
programming procedure is finished after 10 seconds, and normal operation
starts automatically with the new parameter set.
The HOT-KEY can be removed.
The following messages are possible at the end of the data transfer:
end for a correct data transfer
err for a failed data transfer
In this case, briefly switch off the power to the device to repeat the
procedure. If you want to cancel the procedure, simply remove the HOT-
KEY.
UPLOAD (CONTROL DEVICE HOT-KEY)
Writing the current default parameters of the control device into the HOT-KEY:
Insert the HOT-KEY into the provided position when the controller is
switched on again.
Operate 1x with
Press the SET button in order to start the data transfer. uPL starts to blink.
You can remove the HOT-KEY again after about 10 seconds.
The following messages are possible at the end of ther data transfer:
end for a correct data transfer
err for a failed data transfer
In this case, press the SET button again to repeat the procedure. If you
want to cancel the procedure, remove the HOT-KEY.
16 - 0911
CONTROL DEVICE)
. The message uPL can be seen in the display.

Publicité

Table des Matières
loading

Table des Matières