Roland OCTAPAD SPD-20 PRO Manuel Du Propriétaire page 16

Creating a Kit
PAD COMP settings
Parameter Value
ON/OFF ON, OFF
KICK 1, KICK 2,
SNARE 1,
SNARE 2, TOM 1,
TOM 2,
TYPE
CYMBAL 1,
CYMBAL 2,
SOFT COMP,
HARD COMP,
LIMITER
Gain -24.0–+24.0dB
Thre -48–0dB
1:1, 2:1, 3:1, 4:1, 8:1,
Ratio
16:1, 32:1, 100:1
HARD, SOFT1,
Knee
SOFT2, SOFT3
Attack 0.1–100ms
Release
10–1000ms
PAD MUTE GROUP and PAD LINK settings
1. From the [OTHER] button items, select PAD MUTE
GROUP or PAD LINK, and press the [ENTER] button.
2. Press the [ENTER] button once again.
To cancel a specified mute/link, use the [K][J] buttons to select
"RESET, " and then press the [ENTER] button.
3. Use the [K][J] buttons to specify the group
number.
Up to eight groups can be specified.
16
Explanation
Turns the pad compressor on/off.
Type of compressor
* Changing this parameter sets the pad compressor's Ratio, Knee, Attack, and Release parameters
to optimal values. Based on these settings, you can adjust the value of each parameter as
necessary.
Compressor output volume
Volume level at which compression starts
Compression ratio
Attack of the sound at the moment compression is applied
Time until compression starts
Time until compression returns to the original state
4. Strike a pad to select the pad that you want to mute
or link.
* For EXTERNAL TRIGGER INPUT 1–4, the upper row is HEAD and the
lower row is RIM.
MEMO
5 You can't assign the same pad to different groups. If you attempt
to specify this, the following message appears.
5 You can't use Pad Link to assign three or more pads to the same
group. If you attempt to specify this, the following message
appears.
PAD1–8 EXTERNAL TRIGGER INPUT 1–4