Editing The Sound Of The Overall Kit - Roland OCTAPAD SPD-20 PRO Manuel Du Propriétaire

Creating a Kit

Editing the Sound of the Overall Kit

* For details on the parameters, refer to "Data List" (PDF).
Button Parameter
KitVolume
PedalHHVolume
KitTempo
KIT COMP
[KITCOMMON]
KIT EQ
KIT NAME
KIT MIDI
KIT RESET
KIT COMP settings
Parameter Value
ON/OFF ON, OFF
TYPE SOFT, HARD, LIMITER
Gain -24.0–+24.0dB
Thre -48–0dB
1:1, 2:1, 3:1, 4:1, 8:1,
Ratio
16:1, 32:1, 100:1
HARD, SOFT1,
Knee
SOFT2, SOFT3
Attack 0.1–100ms
Release
10–1000ms
18
Value Explanation
0–127 Specifies the volume of the entire kit.
0–127 Specifies the volume of the pedal hi-hat.
Specifies the tempo setting of each kit.
If the MFX Tempo Sync is ON, effect settings such as Rate and Delay Time reflect
20–260
the tempo specified here.
* For details on MFX, refer to "Data List" (PDF).
Adjusts the volume dynamics of the entire kit. This makes settings for the
compressor that is applied at the final stage of the output.
–
For details, refer to "KIT COMP settings" (p. 18).
Adjusts the tonal character of the entire kit. You can adjust the amount of boost/
cut for three bands (LOW, MID, HIGH). You can also use this to adjust the tonal
–
character when using KIT COMP.
For details, refer to "KIT EQ settings" (p. 19).
Edits the name of the kit.
–
Use the [K][J] buttons to select the character that you want to edit, and use the
[–][+] buttons to edit it.
Here you can specify the MIDI messages that a pad sends or receives.
–
For details, refer to "KIT MIDI settings" (p. 19).
KIT001–KIT200 Returns the kit to its factory-set state.
Explanation
Turns KIT COMP on/off
Type of compressor
* When you change this parameter, all parameters in KIT COMP are changed to the optimal
settings. Based on these settings, you can edit each parameter as desired.
Output volume of the compressor
Volume level at which compression starts
Compression ratio
Attack of the sound at the moment that compression is applied
Time until compression starts
Time over which compression returns to the original state