Motor Adjustments; Adjusting The Lower Unit For A Secure Stow - MINN KOTA FORTREX Manuel Du Propriétaire

ADJUSTING THE LOWER UNIT FOR A SECURE STOW

MOTOR ADJUSTMENTS

MOTOR ADJUSTMENTS
Adjusting the Lower Unit for a Secure Stow
When the Motor is stowed, the Lower Unit should rest on the Mount Ramps just inside the Motor Rest on the Motor Mount. It
is recommended to secure the motor using the following instructions to avoid damage to the motor and shaft from vibrations
during transport.
1
a. Before transporting the boat over water or land, stow
the motor to determine where the Lower Unit rests
on the Mount.
NOTICE:
The correct positioning of the Lower Unit will
place it directly on the Mount Ramps located on the
Mount Rest.
b. If the Lower Unit does not sit on the Mount
Ramps, deploy the motor so the Depth Collar can
be loosened and the motor can be adjusted to
allow it to rest on the Motor Ramps.
CAUTION
The Lower Unit should be placed on the Mount Ramps
within the Motor Rest Area every time the motor is
transported. If the Lower Unit is improperly placed, either
above or below the Motor Rest Area, damage to the Lower
Unit or Shaft will occur and the Shaft will be incorrectly
captured in the Yoke. Not following the recommended
placement for the Lower Unit will cause damage to the
product and void your product warranty.
28 | minnkotamotors.com
Lower Unit
Mount
Mount Ramp
Mount Rest Area
Yoke Shaft
Mount Ramps
Mount
©2021 Johnson Outdoors Marine Electronics, Inc.