Removal Of Furnace From Base Of Skid - Napoleon HYBRID 150 Instructions D'installation Et D'opération

4.3

REMOVAL OF FURNACE FROM BASE OF SKID

HIGH CENTRE OF GRAVITY! USE EXTREME CAUTION TO AVOID TOPPLING OF THE FURNACE
STEP #1:
Push the furnace to one side until close to the weight tipping the skid.
INSTALLER #1 STALLER #1
STEP #2:
Firmly support side of the furnace (near top) to
prevent furnace toppling, when the skid/furnace are
tilted.
LOOSEN OFF LOCK NUT
ADJUSTMENT FOOT
CAUTION
"CRUSH HAZARD"!
INSTALLER #2
STEP #3:
Pull the skid from under the unit, and gently tilt the
furnace upright onto the levelling feet.
HIGH CENTRE
OF GRAVITY
2ND INSTALLER 2N
SUPPORTS
WEIGHT OF UNIT W
FROM TOP
USE EXTREME
CAUTION TO AVOID
TOPPLING OF UNIT,
"CRUSH HAZARD".
SECURING BRACKET
REMOVE LAG BOLT
BASE SKID
INSTALLER #1 STALLER #1
13
FURNACE BASE
INSTALLER #2
W415-0910 / A / 09.16.10