Napoleon HYBRID 150 Instructions D'installation Et D'opération page 31

STEP #16
○ Slide the cover of the oil limit switch off.
○ Attach the oil limit switch to the oil limit switch mounting bracket using (4) hex head wildrill screws, see
following diagram for correct mounting position depending on left or right hand RA requirement.
LEFT HAND RA CONFIGURATION
○ Insert the cylindrical probe of limit switch/bracket assembly into 7/8" hole on either side of the lower section
of rear panel depending on the left or right RA confi guration. Insert limit probe until limit bracket comes up
to fl ush with both rear and side faces of the rear panel. Once seated, the bracket can be secured to the
rear panel using (2) self drilling screws into rear face of panel and (2) self drilling screws into side face of
panel.
○ Secure the fl ex conduit connector on loose end of oil limit wire harness to the access hole on bottom of oil
limit switch connection box using lock nut from within box.
○ Connect the wires from the oil limit wire harness to the oil limit terminals as per Figure A.
○ Secure all the fl ag connectors to the switch terminals and route the ground line to the switch chasis.
○ Confi rm limits on the rotary dial as follows in Figure B.
OIL LIMIT
HARNESS
BLOWER MODULE
LEFT HAND RA CONFIGURATION
HARNESS
OIL FURNACE
FLUE
OIL LIMIT &
MOUNTING
BRACKET
RIGHT HAND RA CONFIGURATION
RIGHT HAND RA CONFIGURATION
OIL
FURNACE
FLUE
OIL LIMIT &
MOUNTING
BRACKET
OIL LIMIT
HARNESS
31
BLOWER
MODULE
HARNESS
W415-0910 / A / 09.16.10