Remove Bowguard From Mount - MINN KOTA FORTREX Manuel Du Propriétaire

2
d. Once the screws are removed, the pin and spacers
can be removed from the Upper Cylinder.
e. Now it is safe to remove the motor from the bow
mount when the motor is in the deployed position.

Remove BowGuard From Mount

1
WARNING
Moving parts can cut or crush. The gas assist lift
mechanism is under pressure. Disconnect gas spring
before removing motor from mount. Do not engage the
pull grip and rope until gas spring is disconnected.
a. With the gas spring disconnected, place the motor in
the deployed position.
b. Remove the 5/16" Allen Screw with a 1/4" Allen
Wrench. The 5/16" Allen Screw is located on the
opposite end of the mount from the hinge that opens
and closes when the mount is stowed and deployed.
c. Once the Allen Screw and Lock Washer are removed,
lift the BowGuard straight up until it is free from
the mount.
©2021 Johnson Outdoors Marine Electronics, Inc.
SERVICE & MAINTENANCE
Outer Arm
Gas Spring Cylinder
Outer Arm
Allen Screw Allen Screw
Lock Washer Lock Washer
BowGuard
NOTICE:
To re-assemble the motor, first refer to the
"Assembly of BowGuard to Mount" section of this Manual.
Once re-assembled, follow the directions for "Installing the
Gas Spring Pin" section of this Manual to re-engage the
Lift Assist.
Pull Grip and Rope Pull Grip and Rope
Mount
Keyways
minnkotamotors.com | 35