MINN KOTA FORTREX Manuel Du Propriétaire page 12

INSTALLING THE MOUNT
3
e. Check the placement with the motor in the deployed
position. When the motor is in the deployed position,
make sure that the Shaft is 1-1/2" out past the
Gunwale of the boat. The lower unit, when stowed
and deployed must not encounter any obstructions.
f. Check the placement of the Hold-Down Strap when
the motor is in the stowed and deployed position and
adjust if necessary.
4
g. Once the Mount is in position, determine which bolt
pattern to use. The bolt pattern selected will depend
on the deck space available on your boat.
NOTICE:
If Pattern 2 is used, the right side plate
must be removed to access the mounting holes in the
base of the Mount.
h. It is recommended to mark at least 4 of the 6 holes
in the base of the Mount and to have two bolts on
each side that are located the farthest apart on the
Mount Plate. Ideal installation would allow for 6
bolts to be used, with a minimum of 4.
i. Drill through the deck of the boat using a 9/32" Drill
Bit on the marked locations.
j. Be sure the Hold-Down Strap under the base of the
Mount Plate sits between the second and third set
of bolts according to the mounting pattern selected.
Double check that it can close around the Mount
when stowed.
WARNING
For installation, do not remove the shaft/motor from the
Bowguard. The Bowguard spring is under tension and must
always remain secured.
12 | minnkotamotors.com
Gunwale Gunwale
Pattern 1
Hold Down Strap
Pattern 2
WARNING
When the motor is being transported, on water or land, it is
important to place the motor completely out of water. The
motor should be positioned up close to the Bowguard. Always
secure the Depth Collar Knob for added security during
transport and then secure the Hold Down Strap. This provides a
secure stow and holds the motor in place during transportation
when it is subject to high levels of shock and vibration. Failure
to secure the motor may result in injury or damage to the unit.
Shaft
1-1/2" 1-1/2"
Minimum Minimum
Bow
©2021 Johnson Outdoors Marine Electronics, Inc.