Routing Connection Cables - MINN KOTA FORTREX Manuel Du Propriétaire

ROUTING CONNECTION CABLES

ROUTING CONNECTION CABLES
Please follow these instructions for routing any and all of the cables present for any pre-installed feature that may come with your
trolling motor. This routing should be followed no matter the type of connection cable present.
1
a. Locate the Universal Sonar cable, at the base of the
Foot Pedal.
CAUTION
Not following the recommended wire routing for the
Universal Sonar cable, may cause damage to the product
and void your product warranty. Route cables away from
pinch points or other areas that may cause them to bend
in sharp angles. Routing the cables in any way other than
directed may cause damage to the cables by being pinched
or severed.
2
b. Identify where the Universal Sonar Cable needs
to be connected and route along an established
routing system in your boat.
c. Use cable ties to loosely secure cables if needed.
NOTICE:
After the cable(s) exit(s) the Foot
Pedal, it should be routed through an established
routing system on the boat, in an area with minimal
interference. Power cables or other elements that may
produce interference for the sonar signals. Inspect
the selected route carefully to ensure that there are
no sharp edges, obstacles, or obstructions that may
damage the cables.
18 | minnkotamotors.com
Heel End Heel End
Foot Pedal Foot Pedal
Universal Sonar Universal Sonar
Foot Pedal Foot Pedal
CAUTION
Improperly securing the Connection Cables may cause damage
to the product and void your product warranty. Do not over
tighten the cable ties as it may damage the wires.
Toe End Toe End
Power Cables Power Cables
Power Cables Power Cables
Universal Sonar Universal Sonar
©2021 Johnson Outdoors Marine Electronics, Inc.