Electrical Section - Elba EX 106 M Mode D'emploi

3

ELECTRICAL SECTION

IMPORTANT: The appliance must be installed by a qualified technician according
with the current local regulations and in compliance with the manufacturer
instructions. Incorrect installation might cause harm and damage to people,
animals or objects, for which the manufacturer accepts no responsibility.
Before carrying out any work on the electrical section of the appliance, it must be
disconnected from the mains.
Connection to a good earth wiring system is absolutely essential.
The manufacturer accepts no responsibility for any inconvenience caused by
failure to comply with this rule.
GENERAL
Connection to the mains must be carried out by qualified personnel in accordance with
•
current regulations.
• The appliance must be connected to the mains checking that the voltage corresponds
to the value given in the rating plate and that the electrical cable sections can withstand
the load specified on the plate.
Models supplied with plug: The plug must be connected to an earthed socket in
•
compliance with safety standards.
Models supplied without plug: The appliance is supplied without a power supply plug
•
and therefore if you are not connecting directly to the mains, a standardized plug
suitable for the load must be fitted.
The appliance can be connected directly to the mains placing an omnipolar switch
•
with minimum opening between the contacts of 3 mm between the appliance and the
mains.
The power supply cable must not touch the hot parts and must be positioned so that it
•
does not exceed 50°C at any point.
Once the appliance has been installed, the switch or socket must always be accessible.
•
If the power supply cable is damaged it must be substituted by a suitable cable
•
available in the after sales service.
N.B. For connection to the mains, do not use adapters, reducers or branching
devices as they can cause overheating and burning.
If the installation requires alterations to the domestic electrical system or if the socket and
appliance plug are incompatible, call an expert.
He should also check that the socket cable section is suitable for the power absorbed by
the appliance.
24 24