Elba EX 106 M Mode D'emploi page 52

To remove the RH and LH sliding guides from the wire support:
Find the safety locks. These are the tabs that clip over the fixing wire (arrow 1 in fig. 6.12).
•
Pull the safety locks away from the fixing wire to release the sliding guide (arrow 2 in fig. 6.12).
•
Cleaning the sliding shelf supports:
Wipe the supports with a damp cloth and a mild detergent only.
•
Do not wash them in the dishwasher, immerse them in soapy water, or use oven
•
cleaner on them.
ADVICE FOR USE AND MAINTENANCE OF SELF CLEANING PANELS
The self cleaning panels are covered with a special microporous enamel which, absorbs
and removes oil and fat splashes during normal baking over 200°C.
If, after cooking very fatty foods, the panels remain dirty, operate the oven empty on max
temperature for about 30 minutes.
These panels do not require to be cleaned, however it is advised to periodically remove
them from the oven (at least the side panels) and to wash them with tepid soapy water and
then wipe off with a soft cloth.
DO NOT CLEAN OR WASH THEM WITH ABRASIVE PRODUCTS OR WITH PRODUCTS
CONTAINING ACIDS OR ALKALIS.
The side panels are reversible and when the microporous enamel degrades, they can be
turned to the other side.
52 52
1
2
1
Fig. 6.12