Elba EX 106 M Mode D'emploi page 25

ELECTRICAL FEEDER CABLE CONNECTION
Important! This appliance must be connected to the electricity supply only by an
authorised person.
WARNING: If the power supply cable is damaged, it must be replaced only by an
authorised service agent in order to avoid a hazard.
To connect the supply cable:
Remove the screw securing the cover "A" on the rear of the cooker (fig. 3.1).
•
Unscrew cable clamp "D" (fig. 3.2).
•
Connect the wires to the terminal block "B" as shown in the diagram in figure 3.3.
•
Take up any slack in the cable and secure with the cable clamp "D".
•
• Replace the cover "A".
Note: The earth conductor must be left about 3 cm longer than the others.
A
Fig. 3.1
Fig. 3.2
FEEDER CABLE SPECIFICATIONS
•
220-240 V ac
(*)
(**) Connection with wall box connection.
B
D
Fig. 3.3
Type H05RR-F
H05V2V2-F"
temperatures of 90°C)
3 X 1,5 mm
Connection possible with plug and
outlet
230 V
220-240 V ac
L1 PE
or Type
(resistance to
(*) (**)
2
N(L )
2
25 25