Elba EX 106 M Mode D'emploi page 18

POSSIBLE GAS CONNECTIONS
GAS CONNECTION WITH A RUBBER HOSE
Imporant!
A rubber hose connection shall only be made if permitted by the applicable local
regulations.
The gas connection is made up of:
the terminal fitting of the inlet pipe (right-hand or left-hand);
•
sealing washer;
•
the appropriate hose holder (for Natural gas or LPG). If not supplied with the appliance
•
it can be purchased by contacting the After-Sales Service.
Connecting the cooker to Natural gas
If not already fitted, fit the Natural gas hose holder on the inlet pipe, making sure that
1.
you place the sealing washer between them (as shown in fig. 2.2).
Connect the cooker to the gas supply using a suitable rubber hose (internal diameter
2.
15 mm).

The hose must comply with the applicable local regulations and be of the correct
construction for the type of gas being used.
Make sure that the hose is tightly and securely fitted at both ends.
3.
Use a standard hose clamp (not supplied) to fasten the hose.
4.
Connecting the cooker to LPG
If not already fitted, fit the LPG hose holder on the inlet pipe, making sure that you
1.
place the sealing washer between them (as shown in fig. 2.2).
Connect the cooker to the gas supply using a suitable rubber hose (internal diameter
2.
6 mm).

The hose must comply with the applicable local regulations and be of the correct
construction for the type of gas being used.
Make sure that the hose is tightly and securely fitted at both ends.
3.
Use a standard hose clamp (not supplied) to fasten the hose.
4.
5. Install a gas pressure regulator.
Important!
To comply with applicable local regulations, a gas pressure regulator (conforming
to the local regulations in force) must be installed when connecting the cooker to an
LPG cylinder.
When connecting the cooker to the gas supply with a rubber hose, make sure that
the hose is as short as possible, without twists or kinks.
•
the hose is not longer than 750 mm (or refer to applicable local regulations) and does
•
not come into contact with sharp edges, corners or moving parts. Use a single rubber
hose only; never connect the appliance with more than one rubber hose.
the hose is not under tension, twisted, kinked, or too tightly bent, neither while the
•
appliance is in use nor while it is being connected or disconnected.
the hose does not come into contact with any part of the cooker with a surface
•
temperature of 70°C or above (or refer to applicable local regulations).
the hose is not subject to excessive heat by direct exposure to flue products or by
•
contact with hot surfaces.
the hose can easily be inspected along its entire length to check its condition.
•
18 18