Elba EX 106 M Mode D'emploi page 16

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

2
GAS SECTION
GAS INSTALLATION REQUIREMENTS
Important !
This appliance must be installed and serviced only by a suitably qualified,
registered installer. The installer shall refer to the local standards in force.
Failure to install the appliance correctly could invalidate any manufacturer's
warranty.
Before installation, make sure that the local distribution conditions (gas type and
pressure) and the adjustment of this appliance are compatible. The appliance
adjustment conditions are given on the plate or the label.
If the gas pressure (for which the appliance is to be used) is variable or if it is
not within the values indicated on the rating plate, it is mandatory to install a
proper gas pressure regulator which must be adjusted to guarantee the correct
operating pressure to the appliance (as per rating plate).
The regulator must be installed, adjusted and tested by a qualified technician.

WARNING: Using the appliance with a wrong and/or variable gas pressure may
be extremely dangerous and may result in serious injury to the user. Damage to
the appliance could occur if not observing this condition.

The manufacturer declines every responsibility for any inconvenience resulting
from the inobservance of this condition.
This appliance is supplied for use on LPG (check the gas regulation label attached on the
appliance).
This appliance is supplied for use on Natural gas or LPG (check the gas regulation label
attached on the appliance).
Appliances supplied for use on Natural gas: they are adjusted for this gas only and
cannot be used on any other gas (LPG) without modification. The appliances are
manufactured for conversion to LPG.
Appliances supplied for use on LPG: they are adjusted for this gas only and cannot
be used on any other gas (Natural gas) without modification. The appliances are
manufactured for conversion to Natural gas.
If the Natural gas/LPG conversion kit is not supplied with the appliance this kit can be
purchased by contacting the After-Sales Service.
FOR SOUTH AFRICA ONLY
The appliance is predisposed and adjusted to operate with the gas G30/G31 (LPG USE).
Operating pressure: 2,8 kPa.
This appliance is manufactured for conversion to G20 (NATURAL GAS) if required and is
supplied with a conversion kit.
This appliance must only be connected to NATURAL GAS after a NATURAL GAS
conversion kit has been fitted.
16
16
OR

Publicité

Table des Matières
loading

Table des Matières