Elba EX 106 M Mode D'emploi page 19

the hose is replaced at the printed due date or if it shows signs of wear or damage, and
•
replaced regardless of its condition after a maximum of three years.
you inform the customer that the gas cylinder valve or the gas supply valve immediately
•
by the cooker should be closed when the cooker is not in use.
you inform the customer that the hose should not be subjected to corrosion by acidic
•
cleaning agents.
After connecting the cooker to the gas supply, make sure that you
check that the connections are correctly sealed using a soapy solution, but never a
•
naked flame.
check whether the injectors are correct for the type of gas being used. If not, follow the
•
instructions under "GAS MAINTENANCE".
replace the sealing washer/s on the slightest sign of deformation or imperfection. The
•
sealing washer/s is/are the part/s which guarantee/s a good seal in the gas connection.
use two spanners when fitting the hose holder (fig. 2.2).
•
Note: if not already fitted on the inlet pipe, the hose holders are supplied
with the product in a separate kit; if not supplied with the appliance
they can be purchased by contacting the After-Sales Service.
(Important: to be used ONLY IF PERMITTED by the local applicable regulations)
(#) If not already fitted on the inlet pipe,
it is supplied with the appliance in a
separate kit
Rubber hose (not supplied)
for LPG connection
(internal diameter 6 mm)
Gas connection with rubber hose holders
Inlet pipe
Manifold
male
pipe fitting
Sealing
washer (#)
1/2" G cylindrical
(ISO 228-1) female
Hose holder
for LPG
Hose clamp
(not supplied)
LPG
1/2" G cylindrical
(ISO 228-1) male
1/2" G cylindrical
(ISO 228-1) female
Hose holder
for
Natural gas
Hose clamp
(not supplied)
Rubber hose (not supplied)
for Natural gas connection
(internal diameter 15 mm)
NG
Fig. 2.2
19 19