Electrical Section - Elba DOMINO COOKING HOBS Mode D'emploi

8
8
IMPORTANT: Installation has to be carried out according
to the instructions provided by the manufacturer.
Incorrect installation might cause harm and damage to
people, animals or objects, for which the manufacturer
accepts no responsibility.
DETAILS
Connection to the electric power supply must be carried out
by a qualified technician and following the appropriate safety
regulations;
Before carrying out the connection to the power supply, the
voltage rating of the appliance (stamped on the appliance
identification plate) must be checked for correspondence to
the available mains supply voltage, and the mains electric
wiring should be capable of handling the cooker's power rat-
ing (also indicated on the identification plate);
The appliance is supplied without a power supply plug and
therefore if you are not connecting directly to the mains, a
standardized plug suitable for the load must be fitted.
The power point must be connected to a suitable earth wiring,
in conformity to current safety regulations.
The colours of the wires in the hob power cable may not cor-
respond with the colours marked on the terminals of your
electrical plug. The plug should in any case be wired as fol-
lows:
– connect the green/yellow wire to the terminal marked with
the letter PE or the earth symbol or coloured green/yellow;
– connect the blue wire to the terminal marked with the letter
N or coloured black;
– connect the brown wire to the terminal marked with the let-
ter L or coloured red.
It is possible to connect the appliance directly to the mains
supply by means of a heavy duty switch with 3 mm minimum
distance between the contacts.
The power supply cord must not touch against any hot sur-
faces and must be placed so that its temperature does not
exceed 75°C at any point along its length.
After having installed the appliance, the power switch or
power plug must always be in a accessible position.
The appliance must have its own supply; any other appliances
installed near it must be supplied separately.
– N.B. For connections to the mains power supply, never use
adaptors, reductions or multiple power points as these may
overheat and catch fire.
In the event that installation should require modifications to the
mains supply wiring system, it is recommended that a qualified
technician be called to carry out substitution.
The technician will also have to verify that the cross-section of
the electric cables on the power point match the appliance's
power rating.
Connection to a good earth wiring system is absolutely
essential.
The manufacturer accepts no responsibility for any inconve-
nience caused by failure to comply with this rule.

ELECTRICAL SECTION

A double pole switch must be provided no further than 2 metres
from the appliance to the electrical supply.
If you are using the hob for the first time, or after a period of dis-
use, you should set the controls to position 1 for approximately
30 seconds, to dry out any humidity.
This appliance must be connected by a competent person,
using fixed wiring via a DOUBLE POLE SWITCHED FUSED
SPUR OUTLET.
We recommend that the appliance is connected by a qualified
electrician, who is a member of the N.l.C.E l C. and who will
comply with the l.E.E. and local regulations.
The wires in the mains lead are coloured in accordance with the
following code:
Green & Yellow = Earth
Blue = Neutral
Brown = Live.
As the colours of the wires in the mains lead for the appliance,
may not correspond with the coloured markings identifying the
terminals in your spur box, proceed as follows:
1) The wire which is coloured green and yellow must be con-
2) The wire which is coloured blue must be connected to the ter-
3) The wire which is coloured brown must be connected to the
DOUBLE POLE SWITCHED
FUSED SPUR OUTLET
FUSE
USE A 3 AMP FUSE
for gas hobs use a 3 amp FUSE
for electric hobs use a 20 amp FUSE
nected to the terminal marked E (Earth) or
Green.
minal marked N (Neutral), or coloured Black.
terminal marked L (Live), or coloured Red.
Before carrying out any work on the electrical section of
the appliance, it must be disconnected from the mains.
If the hob surface is cracked disconnect the appliance
from the mains.
ON
coloured
37