Set Entry And Exit Delay Time - Smanos X300 Manuel D'utilisation

3. The control panel replies with SMS
After the control panel receives the SMS, the status LED flashes quickly. The control
panel replies SMS to your smart phone with the content: Change zone name
successfully.
Change zone name successfully.
Note: The first connected sensor is regarded as Zone 1; the second connected sensor is
regarded as Zone 2, and so on. Remote controls do not involve zones.
The zone name can be 30 characters at most for each line. If the character limit is exceeded,
the control panel replies SMS to your smart phone:
please correct.
Other zone names are fixed, zone 10 alarm, zone 11 alarm, and so on.
If the input format or content is incorrect, the control panel replies:

Set entry and exit delay time

Entry and exit delay means delaying arm before leaving your home; delaying alarm
after entering your home. If you do not want to take the remote control, entry and exit
delay time can be set. For example, set the entry/exit delay time to 30 seconds. When
you arm the system before leaving your home, the control panel beeps once every
two seconds. reminding you to leave. The reminding rhythm will speed up in the last
15 seconds. The system spares you 30 seconds before arming. When you enter the
home, the system in arm state sounds the alarm 30 seconds later, sparing you time to
disarm.
51
Zone name more than 30 characters,
Wrong input!
1. Tap [Entry and Exit Delay]
Tap the added account. The main interface appears. Tap
interface for setting entry and exit delay time appears.
2. Set the delay time
The delay time is set as seconds. Then, tap
for sending SMS. Tap [Send] to send the SMS to the phone number of the control
panel.
X300
0 Seconds
Alamy delay time (0-300
[Entry and Exit Delay] . The
[DONE] . The interface is redirected to that
EN
52