Remove The Sim Card; Install The Control Panel - Smanos X300 Manuel D'utilisation

③ Power on the control panel
Slide the switch on the bottom of the control panel from OFF to ON.
OFF-ON
POWER
12V/0.5A
OFF-ON
POWER
12V/0.5A
④ Testing succeeds
If the network LED flashes once every 1 second, it indicates searching the network. 10
seconds later, the network LED flashes once every 3 seconds, it indicates the testing
succeeds.
Note: In daily use, it is recommended to use AC power supply. The built-in rechargeable
battery should be used only in the case of no AC power.
A GSM SIM card with normal functions (calling, answering, SMS and caller ID display) is
required.
Insert the SIM card only after the control panel is switched off (Slide the switch from ON to
OFF). Then, switch on the control panel so as to search signals.
If no SIM card is inserted, you can neither receive alarm notification by SMS or phone call, nor
setting the control panel by phone. However , other functions are not affected.
The volume of built-in siren reaches 105 dB. T o enhance deterring effect, you can add strobe
sirens.
09
SIM

Remove the SIM Card

Switch the control panel (from ON to OFF). Push the SIM card to eject it.
OFF-ON
POWER
12V/0.5A

Install the Control Panel

After the previous testing and the control panel works properly, you can start to install it.
After all setup is completed, attach the control panel to the stand according to the
notch. Secure screws. Then, you can place the control panel on the desk. It is
recommended to enable the tamper protection after installation and all the system
setting are done.
Note: Try to place the control panel in the center of the system or open area for optimal
performance. Avoid load-bearing walls or home appliances that may cause signal attenuation.
SIM
TAMPER
OFF-ON
10
EN